Horner-apg GPS Receiver Bedienungsanleitung PDF herunterladen (Seite 2)

Wiring Diagram

GPS XLe(MJ2)

1 Yellow (Not Used)

2 Red ---------------------------------------------- Supply Voltage 5 VDC

3 Black (small) ---------------------------------- 6 Ground

4 White ------------------------------------------- 7 RXD

5 Black (Thick) ---------------------------------- Supply Voltage Common (0V)

6 Green -------------------------------------------- 8 TXD

Configuration inside of CsCAPE (v8.10 or higher)

Use comm. Port 2 (MJ2) on the XLe. This will keep you programming port (MJ1) available for CsCAPE programming,

diagnostics, and troubleshooting.

Use CsCAPE to set MJ2 protocol to the GPS protocol

1. Open CsCAPE

2. Set the hardware configuration to your

model of XLe

3. Select Program then Protocol Config…

4. From the drop down list on MJ2 select

GPS Protocol v1.03

This will add the GPS Protocol to the MJ2

field. You are now ready to start the three

steps required for any protocol

configuration

5 VDC

1 2 3 4 5 6

Keine Kommentare

Horner-apg GPS Receiver Bedienungsanleitung Seite 2