Horner-apg RCS SmartStix Bedienungsanleitung PDF herunterladen (Seite 22)

PAGE 22 15 MAR 2003 CH.2

MAN0305-04

2.2 MiniRCS Mounting Requirements

2.2.1 MiniRCS Mounting Procedures (Installed in a Panel Box)

The MiniRCS is designed for permanent installation in a panel box. To install the MiniRCS in a panel

box, use the instructions that follow:

1. Prior to mounting the MiniRCS, observe requirements for the panel layout design and adequate

clearances. A checklist is provided on page 25.

2. Drill holes as described in the Figure 2.9.

3. Install and tighten washers and nuts. Do not over-tighten.

4. Connect the communications and power cables to the MiniRCS ports using the provided connectors.

5. Begin configuration procedures for the MiniRCS models.

2.2.2 MiniRCS Dimensions and Panel Cut-outs

Figure 2.9 – MiniRCS Dimensions / Mounting Holes and MiniRCS Side View

Warning: Make sure the power and network connectors are removed from the MiniRCS.

001RCS001

0.91 [23.19mm] 4.00 [101.60mm]

0.19

[4.78mm]

3.75

(95.25mm)

4.13

(104.78mm)

5.83 [147.98mm]

1.83 [46.48mm]

MOUNTING HOLES FOR

#6 OR M3.5 HARDWARE

4 PLCS.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Keine Kommentare

Horner-apg RCS SmartStix Bedienungsanleitung Seite 22