Horner-apg XL6 OCS Bedienungsanleitung PDF herunterladen (Seite 31)

MAN0883-05-EN CH.7

March 4, 2010 Page 31 of 135 #1037

CHAPTER 7: ETHERNET COMMUNICATION (XL6E ONLY)

Note: Xl6e Models namely HE-XL1Ex / HEXT351Cxxx support onboard / built in Ethernet port. It provides

advanced Ethernet Communication capabilities.

7.1 Ethernet Module Protocols and Features

The following table describes the Ethernet Module Protocols and features supported by XL6e.

Protocol / Feature Protocol / Feature Description

ICMP Ping Internet Control Message Protocol

EGD (Peer) GE Fanuc Ethernet Global Data

SRTP Server GE Fanuc Service Request Transfer Protocol

CsCAN TCP Server Horner APG CsCAN over Ethernet

Modbus TCP Slave Modbus over Ethernet

Ethernet / IP Server ODVA CIP over Ethernet

FTP Server File Transfer Protocol

HTTP Server HyperText Transfer Protocol (Web Server)

7.2 Ethernet System Requirements

Full Ethernet functionality requires:

1. PC running Cscape Programming Software Version 8.7 with upgrade or later (for configuration).

2. XL6e controller with onboard Ethernet port.

3. FTP & HTTP protocols.

7.3 Ethernet Module Specifications

Speeds 10 BaseT Ethernet (10-Mbps)

100 BaseTx Fast Ethernet (100-Mbps)

Modes Half or Full Duplex

Auto-Negotiation Both 10/100-Mbps and Half/Full Duplex

Connector Type Shielded RJ-45

Cable Type

(Recommended)

CAT5 (or better) UTP

Port Auto MDI/MDI-X

7.4 Ethernet Module Configuration

Note: The following configuration is required for all applications regardless of the protocols used.

Additional configuration procedures must be performed for each protocol used.

To configure the Ethernet Module, use Cscape Programming Software to perform the following steps

1. On the main Cscape screen, select the Controller menu and its I/O Configure sub-menu to

open the I/O Configuration dialog (Figure 7.1)

2. If configuring a different OCS Model than the one shown in the I/O Configuration dialog, click

on the topmost Config button, select the desired OCS Model, and then click OK

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 134 135

Keine Kommentare

Horner-apg XL6 OCS Bedienungsanleitung Seite 31