Horner-apg XLt OCS Bedienungsanleitung PDF herunterladen (Seite 43)

MAN0878-04-EN CH. 10

August 12, 2009 Page 43 of 100 ECN # 979

Synchronous modes synchronize the reset (or set) to the selected quadrature input and the

selected marker polarity. Figure 10.1 below indicates which mode to select based on the markers

timing diagram. Consult the documentation provided with your encoder to determine the marker

pulse timing.

Note that the Marker input is sampled within 50 micro seconds of the associated

quadrature edge. It is left to the user to determine if this meets the time

constraints of the measured drive.

Note that if the Marker input pulse consecutively spans more than one of the

specified edges, quadrature-decoding operation is unpredictable.

Sync mode selection Waveforms (Clockwise Rotation )

__________________________________________________________________

[1]

[2]

High, Reset on 2 rising [SYNC]

High, Reset on 1 falling [SYNC]

High, Reset on 2 falling [SYNC]

High, Reset on 1 rising [SYNC]

*While not displayed in this figure, modes for low level (inverse logic) are also supported

for each state.

Figure 10.1 – Sync pulse mode illustration

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 99 100

Keine Kommentare

Horner-apg XLt OCS Bedienungsanleitung Seite 43