Horner-apg XLt OCS Bedienungsanleitung PDF herunterladen (Seite 55)

MAN0878-04-EN CH. 11

August 12, 2009 Page 55 of 100 ECN # 979

The first five System Diagnostics are critical. If any of them indicate a Fault condition, the XLe/XLt will not

enter or remain in Run mode, and the problem must be investigated and corrected.

System Ram: Ok = System RAM power-up self-test passed

Fault = System RAM power-up self-test failed

System BIOS: Ok = System BIOS power-up self-test passed

Fault = System BIOS power-up self-test failed

Firmware: Ok = Firmware power-up self-test passed

Fault = Firmware power-up self-test failed

Logic Error: Ok = All executed ladder instructions are legal for loaded firmware

Fault = A ladder instruction not

supported by firmware was found

User Program: Ok = Ladder program and I/O configuration loaded successfully

Fault = Ladder program or I/O configuration not loaded or load failed

The last nine System Diagnostics are informational. If any of them indicate a Warning condition, the

XLe/XLt can still enter and remain in Run mode, but the problem should be investigated and corrected.

User Graphics: Ok = Application graphics objects loaded successfully

Fault = Application graphics objects not loaded or load failed

W-Dog Trips: 0 = Watchdog timer has not tripped since the last power-up

x = Number of times watchdog timer has tripped

Net Errors: 0 = No CAN network bus-off errors have occurred

x = Number of CAN network bus-off errors that have occurred

Network State: Ok = At least one other node was found on the CAN network

Warning = No other nodes were found on the CAN network

Network ID: Ok = This node’s CAN Network ID is in the range 1 to 253

Warning = This node’s CAN Network ID was out of range at power-up

Dup Net ID: Ok = This node’s Network ID is unique on the CAN network

Warning = This node’s Network ID is duplicated in another node

Clock Error: Ok = Time and date have been set

Warning = Time and date need to be set

I/O System: Ok = I/O configuration matches the installed I/O and COM modules

Warning = I/O configuration needs updating to match installed modules

Battery: Ok = Backup battery operating properly

Warning = Backup battery needs to be replaced

View I/O Slots

The View I/O Slots Sub-Menu displays two System Settings, both of which are not

editable.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 99 100

Keine Kommentare

Horner-apg XLt OCS Bedienungsanleitung Seite 55